FM UCFL205 208 210 Oval Flange Ball Bearing Unit with Extended Inner Bearing And Cast Iron Housing

UCFL205 is suitable for applications where the direction of rotation is constant or alternating. The bearing is mounted in a cast iron housing, which can be bolted to a machine wall or frame. Ball bearing units can accommodate moderate initial misalignment, but normally do not permit axial displacement.

• Resist high levels of contamination

• Designed for high temperatures and speeds

• Accommodate relatively heavy loads

• Cost-effective

Dimensions

Performance

• consisting of a ball bearing insert UC 205 and a cast iron housing FL 205

• the design as a 2-hole flange bearing allows installation in a variety of applications, even with limited space at the installation site and is suitable for high radial loads

• the housing is made of cast iron and therefore inexpensive and robust

• the bearing insert has an extended inner ring with grub screws

• The flange bearing is mounted on the shaft using two grub screws

• smooth running and good behavior with tilting due to the extended inner ring

• static misalignments can be compensated up to an angle of 2°

• two-piece sealing system: with sheet steel washer reinforced rubber seal inside; outside additionally with upstream slinger made of sheet steel for high mechanical protection against foreign matter

• lubricated for life; under normal operating conditions relubrication is not required

• housing with integrated lubrication hole